New CCNA – New Questions 2

[phanthanhphong]

Question 2


Q2 (Etherchannel Questions that goes like this)
Refer to the exhibit. Etherchannel has been configured on Switch1 as shown.

Switch1# conf t
Switch1(config)# interface range gigabitethernet 1/1
Switch1(config)# Channel-group 5 Mode “AUTO”
Switch1#
Switch1(config)# interface range gigabitethernet 1/2
Switch1(config)# Channel-group 5 Mode “AUTO”


Which is the correct command set to configure etherchannel on Switch2?


A.
Switch2# configure terminal
Switch2(config)# interface range gigabitethernet3/1 -2
Switch2(config-if)# channel-group 5 mode auto

B.
Switch2# configure terminal
Switch2(config)# interface range gigabitethemet3/1 -2
Switch2(config-if)# channel-group 5 mode passive
C.
Switch2# configure terminal
Switch2(config)# interface range gigabitethernet3/1 -2
Switch2(config-if)# channel-group 5 mode desirable
D.
Switch2# configure terminal
Switch2(config)# interface range gigabitethernet3/1 -2
Switch2(config-if)# channel-group 5 mode ACTIVE

Answer: C

Good resource: http://www.cisco.com/en/US/docs/swit...html#wp1028480

Question 3


Which OSPF command turn OSPF on all interfaces of a router?

Answer: network 0.0.0.0 255.255.255.255


Question 4


Network admin creates a layer 3 Etherchannel, bounding 4 interfaces into channel group 1. On what interface is the IP address configured?
A. the port-channel 1 interface
B. the highest number member interface
C. all member interfaces
D. the lowest number member interface


Answer: A